Lead2pass Offers Free 300-360 Dumps Files for Free Downloading By 300-360 Exam Expert:

https://www.lead2pass.com/300-360.html

QUESTION 31
After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?

A.    The area is below the minimum threshold configured on the tool.
B.    The area is below the detectable level and indicates no RF signal.
C.    The area is below -100 dBm at coverage cell edge.
D.    The area is below -67 dBm at coverage cell edge.

Answer: A

QUESTION 32
An engineer must design wireless coverage in thick-walled stairwells. Which information should the engineer refer to when determining where APs can be installed?

A.    Local or National Building Code
B.    IEEE
C.    BICSI TDMM
D.    Cisco Hardware Installation Guide

Answer: D

QUESTION 33
An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. Which of the following is a requirement for the design?

A.    overlapping -72 dBm coverage from two access points
B.    overlapping -67 dBm coverage from two access points
C.    continuous -67 dBm coverage from one access point
D.    continuous -72 dBm coverage from one access point

Answer: C

QUESTION 34
A network engineer is preparing for an office site survey with a height of 2.5 meters. Which three components are recommended to complete the survey? (Choose three.)

A.    Use APs with external antennas.
B.    Use DoS attack on APs while measuring the throughput.
C.    Use APs with built-in antennas.
D.    Use a battery pack to power APs.
E.    Use a drawing of the office space to draw AP and client placements.
F.    Use APs with directional antennas.

Answer: CDE

QUESTION 35
An engineer is planning for a 24 Mbps data rate for a new installation.
What is the coverage area from the AP if the environment and other factors are not taken into consideration?

A.    225 feet
B.    80 feet
C.    150 feet
D.    100 feet

Answer: A

QUESTION 36
Which two options describe best practices that must be completed after a wireless installation is finished? (Choose two.)

A.    Make sure that there are no spaces between the devices on the rack that the Wireless Lan Controller isinstalled.
B.    Consult with the customer to ensure that the IT staff has a complete set of design and installationdocuments.
C.    Make sure the customer is aware that they should consider purchasing a support contract immediately afterthe installation is complete.
D.    Spend time with the customer to show them the controller GUI and inform them how they can reach theCisco TAC if they have any problems.
E.    Test all the customer’s wireless devices and applications to ensure they are working properly.

Answer: BE

QUESTION 37
A customer is deploying a Greenfield 802.11ac network on a floor that will support approximately 300 wireless devices. Which setting needs to be changed on Prime Infrastructure Planning Tool in order to predict the amount of access points the customer needs to service the new floor?

A.    Data Coverage Support Margin
B.    Demand Settings
C.    Add AP Field
D.    802.11n Protocol Support

Answer: B
Explanation:
http://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/1-2/configuration/guide/pi_12_cg/maps.html#pgfId-1671104

QUESTION 38
What is the recommended minimum speed at the edge of the cells in an 802.11g network for a good Cisco VoWLAN deployment?

A.    11 Mb/s
B.    36 Mb/s
C.    12 Mb/s
D.    18 Mb/s

Answer: C

QUESTION 39
An engineer is conducting a location readiness test and wants a selected point to be considered location-ready. Which three possible configurations reflect the minimum number of APs needed? (Choose three.)

A.    One AP is resident in each quadrant surrounding the point-in-question.
B.    One AP per 1400 sq. ft. on the map.
C.    Two APs are resident in each quadrant surrounding the point-in- question.
D.    Four APs are deployed on the floor.
E.    Three APs are within 70 feet (21 meters) of the point-in- question
F.    Three APs are deployed on the floor.

Answer: ADE
Explanation:
http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Borderless_Networks/Unified_Access/CMX/CMX_LocFund.pdf

QUESTION 40
A network engineer is configuring QoS with a DSCP value of 46. To which queue must the CoS be mapped for priority queuing of the voice frames?

A.    1
B.    2
C.    5
D.    4
E.    3

Answer: C

300-360 dumps full version (PDF&VCE): https://www.lead2pass.com/300-360.html

Large amount of free 300-360 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDU1VGRGVieEdJWGM

Maybe you also need:

Large amount of free 300-365 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDSnBMTGlieXBLZWs

Large amount of free 300-370 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDSTdRZ3dTUjVscVU

Large amount of free 300-375 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDaUxFbEpISnFINk0

Lead2pass Provides Free 300-360 Exam Dumps PDF:

https://www.lead2pass.com/300-360.html

QUESTION 21
An engineer is assigned to provide wireless coverage in a provincial capital building. Due to the age and historic nature of the building, the ability to run new copper Ethernet cable to desired AP locations is limited. Which requirement should the engineer specify to overcome this restriction?

A.    Deploy access points where the survey indicates and connect them via fiber optic cable, using a mediaadapter, and locally provide power.
B.    Deploy access points to each phone location converting two spare pairs of copper from the phone line toEthernet and locally provide power.
C.    Deploy access point devices where limited cable can be run or exists and connect high-gain antennas andincrease Tx power to increase cell size.
D.    Deploy RAP where limited cable can be run or exists, and extend coverage using MAP.

Exam 300-360 PDF Free Instant Download From Lead2pass:

https://www.lead2pass.com/300-360.html

QUESTION 11
Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)

A.    Use the Cisco wireless phone site survey client utility.
B.    Use a separate Cisco Wireless Lan Controller.
C.    Enable load balance on voice WLANs.
D.    Maintain -67dBM as a minimal RSSI.
E.    Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
F.    Enable lower data rates for 2.4-GHz data WLAN.

Easily Pass 300-360 Exam By Training Lead2pass New Cisco VCE Dumps:

https://www.lead2pass.com/300-360.html

QUESTION 1
A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping.
How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

A.    No outer CAPWAP or inner QoS tagging is applied.
B.    The outer CAPWAP CoS is marked and capped and the inner DSCP maintains the original marking.
C.    No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.
D.    The outer CAPWAP DHCP is marked and capped without any inner DSCP value.

New Exam 300-360 Dumps From Lead2pass Cover All 300-360 New Questions.v.2017-12-07.140q

https://www.lead2pass.com/300-360.html

QUESTION 95 300-360 Dumps,300-360 Exam Questions,300-360 New Questions,300-360 VCE,300-360 PDF

A wireless engineer is hired to design a network for six buildings with a WLC in each building to support the access points.
Which type of wireless architecture is being used?

A.    distributed deployment
B.    autonomous deployment
C.    unified deployment
D.    centralized deployment

2017 November Cisco Official New Released 300-360 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

I have already passed Cisco 300-360 certification exam today! Scored 989/1000 in Australia. SO MANY new added exam questions which made me headache….. Anyway, I finally passed 300-360 exam with the help of Lead2pass! 

Following questions and answers are all new published by Cisco Official Exam Center: https://www.lead2pass.com/300-360.html

QUESTION 61
When reviewing a design for a voice over wireless deployment, what per-call bandwidth cost should be factored in when determining maximum calls per cell using SIP and G.711u as the codec?

A.    64 bytes
B.    8 bytes
C.    80 bytes
D.     10 bytes